![]() So i guess i just really need the values for R10 and R11 in the SPS400 power supply unit.Hopefully someone knows off hand. Open up the amp section, test the 6 transistors and i found one shorted IFR640n so likely that is the problem, going to see if i have something around that will work for that.Īside from that, everything else seems to check out as far as in circuit testing of parts goes. I did notice that R10 and R11 which feed the +- power to the amp board were burnt up so bad i cant get the color codes. All voltage outputs stable now, other than the -15v was more like -18v. PCB Schematic 3 EUROPOWER PMP6000 Manualzz 3 15 XIN VDD 14 BYPASS 4 13 XOUT GND V1000 MCLK ARST 25 AOUTL+ 26 AOUTL- O2L+ O2L- 24 AOUTR+ 23. Remove all wiring between amp board and power supply and test power supply again. I get 5v,steady, 48v steady 15+steady but the -15 was jumping all over in sync with clicking sound. Open up the unit and measure the voltages off the pwr supply. Power unit on and it just makes clicking sound coming from inside the amp section but nothing out the speakers.Īll mixer inputs and outputs appear to be receiving and sending signal. I cant find the schematics for this thing and there is a couple of parts i need to identify. I come searching for info on the Behringer PMP1000 mixer and found this thread. Hey guys, its been a while since i have been to the forum. BEHRINGER EUROPOWER-P0569HCA2400SPS1000DPXPMP-1280S5000SCH2 SCHEMATICS Service Manual Download the High Quality Digitized PDF, or order a High Quality Paperback Manual, Tech Sheet or Supplement.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |