![]() The speed setting for firt layer is not applied to the “Additions” (Skirt). With 40% speed you get 1440 mm/min for a good stickiness of the first layer. I allways use a first layer high of 0,200mm independet from the quality setting because this is best working for my calibration behavior. ![]() A layer is allways started with the most inner wall -> outer wall -> infill. So I chose 0,2400 for the layer high and I think this is the maximum you can get out of a 0,4 nozzle without bigger quality problems.ģ Layers for top, bottom and walls is good start for now and also what Luban does. For “Fast” priting I chose the same settings like in Luban.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |